E 43
0705.USA
6.1 Discharge monitor function
If the discharge monitor function is enabled, the lifting function is switched off when
the battery reaches the discharge limit (Stop LED lights up). Traveling and lowering
are still possible. The residual capacity limit is 20% for wet batteries and 40% for
maintenance-free batteries. You should recharge the battery when the charge level
drops below 30% for wet batteries and 50% for maintenance-free batteries (the
yellow LED lights up as a warning).
6.2 Operating hours indicator
Indicator range between 0.0 and 99,999.0 hours. Travel and lifting movements are
recorded. The display is backlit.
NOTICE With maintenance-free batteries, a "T" symbol appears in the operating hours
indicator (31).
Error messages
The operating hours indicator is also used to display errors. The error display is made
up of two parts and alternates between "C" for component with a three-digit
component number and "E" for error with a three-digit error number.
If more than one error occurs at the same time, they are displayed one after the other.
The error display remains until the error is rectified (always in the combination Cxxx/
Exxx). Error messages overwrite the operating hours indicator. Most errors cause an
emergency stop to be triggered. The error display remains until the control current
circuit is switched off (switch latch).
NOTICE Detailed descriptions of components and error codes can be obtained from
the manufacturer's service organization.
Display for parameter changes (travel programs)
The LCD display (31) and the keypad (CANCODE (o)) can be used to display the
setting parameters. The first three digits of the display show the parameter number,
the last three the parameter value.
NOTICE Settings for parameter group 0XX (code lock) are not displayed.
6.3 Power-up test
When the system is switched on, the following elements are displayed:
– the software version of the display unit (briefly)
– the operating hours,
– the discharge status.
To Next Page
Loading...
Need help?
General
