To Next Page

To Previous Page

0206.GB

E 14

– Fully lower the Aux. lift and raise the

Main lift with the hydraulic control

switch (8) until the forks are clear of

the ground.

– Slowly turn the travel selection switch

(6) with the right thumb.

Turn clockwise = forward travel

Turn anti-clockwise = reverse travel

– You can control the travel speed by

continuing to turn or retracting the tra-

vel selection switch.

Use the steering wheel (2) to steer the

truck in the required direction.

Steering

Use the steering wheel to steer the truck

outside narrow aisles.

The position of the drive wheel is shown

in the display unit (13).

Braking

The braking pattern of the truck depends largely on the ground conditions. The driver

must take this into consideration when handling the truck.

– The truck can be braked in three different ways:

- with the operating brake

- with the parking brake

- with the main switch.

Braking with the operating brake

While driving set the travel direction switch to the zero position or the opposite travel

direction; the traction current controller will cause the truck to brake.

Braking with the foot switch

Releasing the foot switch causes the truck to brake.

This type of braking can only be used as a parking brake and not as an operating

brake.

Braking with the EMERGENCY DISCONNECT switch

Applying the EMERGENCY DISCONNECT switch will cause the truck to brake

suddenly until it comes to a halt.

The EMERGENCY DISCONNECT switch must only be used in dangerous situations.