F 15
0708.GB
5.11 Recommissioning
Recommissioning after cleaning or repair work is permitted only after the following
operations have been performed.
– Test horn operation.
– Test EMERGENCY DISCONNECT switch.
– Test brake operation.
– Lubricate the truck in accordance with the lubrication chart.
6 Decommissioning the forklift truck
If the forklift truck is to be decommissioned for more than one month, e.g. for
operational reasons, it must be parked in a frost-free and dry location and all
necessary measures must be taken before, during and after decommissioning as
described.
M
During decommissioning the truck must be jacked up so that all the wheels are clear
of the ground. This is the only way of ensuring that the wheels and wheel bearings
are not damaged.
If the truck is to be out of service for more than 6 months, further measures must be
taken in consultation with the manufacturer.
6.1 Prior to decommissioning:
– Thoroughly clean the truck.
– Check the brakes.
– Check the hydraulic oil level and replenish as necessary (see Chapter F).
– Apply a think film of oil or grease to all parts not protected by a coating of paint.
– Lubricate the truck in accordance with the lubrication schedule (see Chapter F).
– Charge the battery (see Chapter D).
– Disconnect the battery, clean it and apply grease to the terminals.
Z
In addition, observe the battery manufacturer’s instructions.
– Apply a suitable contact spray to all exposed electrical contacts.
F 15
0708.GB
5.11 Recommissioning
Recommissioning after cleaning or repair work is permitted only after the following
operations have been performed.
– Test horn operation.
– Test EMERGENCY DISCONNECT switch.
– Test brake operation.
– Lubricate the truck in accordance with the lubrication chart.
6 Decommissioning the forklift truck
If the forklift truck is to be decommissioned for more than one month, e.g. for
operational reasons, it must be parked in a frost-free and dry location and all
necessary measures must be taken before, during and after decommissioning as
described.
M
During decommissioning the truck must be jacked up so that all the wheels are clear
of the ground. This is the only way of ensuring that the wheels and wheel bearings
are not damaged.
If the truck is to be out of service for more than 6 months, further measures must be
taken in consultation with the manufacturer.
6.1 Prior to decommissioning:
– Thoroughly clean the truck.
– Check the brakes.
– Check the hydraulic oil level and replenish as necessary (see Chapter F).
– Apply a think film of oil or grease to all parts not protected by a coating of paint.
– Lubricate the truck in accordance with the lubrication schedule (see Chapter F).
– Charge the battery (see Chapter D).
– Disconnect the battery, clean it and apply grease to the terminals.
Z
In addition, observe the battery manufacturer’s instructions.
– Apply a suitable contact spray to all exposed electrical contacts.
To Next Page
Loading...
Need help?
General
