D 5
0504.GB
5 Check the battery condition, the acid level and acid density
– The battery manufacturer’s maintenance instructions apply.
– Check the battery housing for cracks and any spilled acid.
– Remove any oxydation residue from the battery terminals and apply an acid-free
grease to the battery terminals.
– Unscrew the stops and check the acid level.
The acid level should be at least 10-15 mm above the top of the plates.
– Check the acid density in accordance with the battery manufacturer’s instructions
and then refit the stops.
– If necessary, charge up the battery.
6 Battery discharge indicator
When you turn the key in the keyswitch
clockwise and pull the EMERGENCY
DISCONNECT switch, the battery
discharge indicator will show the
residual capacity available. The display
starts to flash when the battery has
reached a residual capacity of 30%. Lift
cut-out occurs at a 20% capacity
display.
For maintenance-free and special
batteries the display and cutout points
can be adjusted by authorised personnel
by assigning parameters.
+-
50%
D 5
0504.GB
5 Check the battery condition, the acid level and acid density
– The battery manufacturer’s maintenance instructions apply.
– Check the battery housing for cracks and any spilled acid.
– Remove any oxydation residue from the battery terminals and apply an acid-free
grease to the battery terminals.
– Unscrew the stops and check the acid level.
The acid level should be at least 10-15 mm above the top of the plates.
– Check the acid density in accordance with the battery manufacturer’s instructions
and then refit the stops.
– If necessary, charge up the battery.
6 Battery discharge indicator
When you turn the key in the keyswitch
clockwise and pull the EMERGENCY
DISCONNECT switch, the battery
discharge indicator will show the
residual capacity available. The display
starts to flash when the battery has
reached a residual capacity of 30%. Lift
cut-out occurs at a 20% capacity
display.
For maintenance-free and special
batteries the display and cutout points
can be adjusted by authorised personnel
by assigning parameters.
+-
50%
To Next Page
Loading...
Need help?
General
