What does Error 338 mean on my Jungheinrich EKS 310 Forklifts?
Error 338 indicates that the foot switch was pressed during the power-up test. To resolve this, do not press the foot switch and switch the truck off and on again.
What does Error 144 mean on Jungheinrich EKS 310 Forklifts?
Error 144 means that the truck has quit the guidance wire. To fix this, restore wire guidance.
What does Error 344 mean on Jungheinrich Forklifts?
Error 344 indicates an issue with the personal safety system. The PSA scanner may be contaminated. Clean the scanner.
What does Error 330 or Error 334 mean on Jungheinrich EKS 310?
Error 330 or Error 334 indicates that the travel control button was pressed during the power-up test. To resolve this, do not press the travel control button; switch the truck off and on again.
What does Error 331 or Error 335 mean on Jungheinrich Forklifts?
Error 331 or Error 335 indicates that the hydraulic control button was pressed during the power-up test. To resolve this, do not press the hydraulic control button; switch the truck off and on again.
What does Error 332 or Error 336 mean on Jungheinrich Forklifts?
Error 332 or Error 336 indicates that a function preselect key was pressed on the control panel during the power up test. To resolve this, do not press any function preselect key, and switch the truck off and on again.
What does Error 339 mean on Jungheinrich EKS 310 Forklifts?
Error 339 indicates that a key was pressed below the display unit during the power-up test. To resolve this, do not press any key, and switch the truck off and on again.
Why won't my Jungheinrich Forklifts load lift?
If the load cannot be lifted, here are some possible reasons: * The truck may not be operational. In this case, carry out all measures listed under “Truck does not start.” * The battery charge may be too low, activating the lift cutout. Check the battery charge and charge the battery if necessary. * There might be insufficient hydraulic oil. Check the hydraulic oil level and replenish if needed. * A fuse might be blown. Check the fuses.
Why is rapid travel disabled on my Jungheinrich EKS 310?
Rapid travel may be disabled due to the following reasons: * The Main Lift / Aux. Lift is raised above 0.5m. Lower the Main Lift / Aux. Lift below 0.5m. * WG search mode is activated. Align the truck or turn off WG mode. * No test run has been performed. Perform lifting and lowering.
What to do if my Jungheinrich EKS 310 Forklifts truck cannot be steered?
If the truck cannot be steered, consider these potential causes: * The truck may not be operational. Perform all the checks listed under “Truck does not start.” * The narrow aisle mode switch may be pressed. Switch off the narrow aisle travel function.
Essential safety rules for handling batteries, including personal protection and disposal.
Step-by-step instructions and safety precautions for charging the truck's battery.
Procedures for safely removing and installing the truck's battery.
Covers driver authorization, responsibilities, unauthorized use, damage reporting, and danger areas.
Details the various controls and display elements on the truck's panel.
Procedures and checks required before starting the truck for daily work.
General| Drive | Electric |
|---|---|
| Load Capacity | 1000 kg |
| Overall Height | 2350 mm |
| Battery Voltage | 24 V |
| Travel Speed | 12 km/h |
To Next Page