C 7
0504.GB
3 Commissioning
3.1 Moving the truck without a battery
M
This operation must only be performed by suitably trained maintenance personnel.
M
This operation is forbidden on slopes and inclines (no brakes).
See also Chapter E, Section 6.9
3.2 Installing and Removing / Assembling and Folding the Mast
M
This operation must only be performed by the manufacturer or a customer service
team authorised by the manufacturer.
4 Commissioning
M
Operate the truck only with battery current. Rectified AC current will damage the
electronic components. The battery leads (tow cable) must be less than 6m in length.
To prepare the truck after delivery or after transport, proceed as follows:
– If necessary, install and charge the battery (see Chapter D, Sections 4 and 3).
– Commission the truck as per instructions (See Chapter E, Section 4).
M
Before commissioning, check the truck
to ensure the tilt safety device (19) is
present.
Check that all safety devices are
present and operational.
19
C 7
0504.GB
3 Commissioning
3.1 Moving the truck without a battery
M
This operation must only be performed by suitably trained maintenance personnel.
M
This operation is forbidden on slopes and inclines (no brakes).
See also Chapter E, Section 6.9
3.2 Installing and Removing / Assembling and Folding the Mast
M
This operation must only be performed by the manufacturer or a customer service
team authorised by the manufacturer.
4 Commissioning
M
Operate the truck only with battery current. Rectified AC current will damage the
electronic components. The battery leads (tow cable) must be less than 6m in length.
To prepare the truck after delivery or after transport, proceed as follows:
– If necessary, install and charge the battery (see Chapter D, Sections 4 and 3).
– Commission the truck as per instructions (See Chapter E, Section 4).
M
Before commissioning, check the truck
to ensure the tilt safety device (19) is
present.
Check that all safety devices are
present and operational.
19
To Next Page
Loading...
