Jungheinrich HC 10 - Starting up the Truck

E 3
0502.GB
3 Starting up the truck
f
The driver must make sure that nobody is within the danger area of the truck before
the truck is switch on or operated or before a load is lifted.
Checks and operations to be performed before starting daily work
– Check the entire truck (especially the wheels and the load lifting device) for dama-
ge.
Switching on the truck
– Check whether the charging cable is connected and finish charging procedure if ne-
cessary (see chapter D9).
– Insert the key into the key switch (4) and turn it clockwise as far as it will go.
A
The discharge control LED (discharge indicator) (3) shows the present battery capa-
city.
– Check whether the fork can be raised and lowered, by using the operating lever (5).
– Check that the brake works (see section 4.2).
The truck is now ready for operation.
E 3
0502.GB
3 Starting up the truck
f
The driver must make sure that nobody is within the danger area of the truck before
the truck is switch on or operated or before a load is lifted.
Checks and operations to be performed before starting daily work
– Check the entire truck (especially the wheels and the load lifting device) for dama-
ge.
Switching on the truck
– Check whether the charging cable is connected and finish charging procedure if ne-
cessary (see chapter D9).
– Insert the key into the key switch (4) and turn it clockwise as far as it will go.
A
The discharge control LED (discharge indicator) (3) shows the present battery capa-
city.
– Check whether the fork can be raised and lowered, by using the operating lever (5).
– Check that the brake works (see section 4.2).
The truck is now ready for operation.