Jungheinrich HC 10 - Picking up and Setting down Loads; Parking the Truck and Rendering It Safe

0502.GB
E 6
4.3 Picking up and setting down loads
m
Before picking up a load, the driver must make sure that the load rests properly on its
pallet and that it does not exceed the maximum load capacity of the truck.
Picking up long loads crosswise is not permitted.
– Move the truck so that the load lifting device passes completely below the load.
Lifting
– Move the operating lever raise / lower fork (5)
to “H” until the desired height has been
reached.
Lowering
– Move the operating lever raise / lower fork (5)
to “S” until the desired height has been
reached.
4.4 Parking the truck and rendering it safe
f
Always render the truck safe when parking it.
Do not park the truck on slopes.
The load lifting device must always be completely lowered.
– Lower the load lifting device.
– Turn the key (4) to the vertical position and remove it.
– Apply the brake using the pedal (1).
0502.GB
E 6
4.3 Picking up and setting down loads
m
Before picking up a load, the driver must make sure that the load rests properly on its
pallet and that it does not exceed the maximum load capacity of the truck.
Picking up long loads crosswise is not permitted.
– Move the truck so that the load lifting device passes completely below the load.
Lifting
– Move the operating lever raise / lower fork (5)
to “H” until the desired height has been
reached.
Lowering
– Move the operating lever raise / lower fork (5)
to “S” until the desired height has been
reached.
4.4 Parking the truck and rendering it safe
f
Always render the truck safe when parking it.
Do not park the truck on slopes.
The load lifting device must always be completely lowered.
– Lower the load lifting device.
– Turn the key (4) to the vertical position and remove it.
– Apply the brake using the pedal (1).