Jungheinrich HC 10 - Driving, Steering, Braking

E 5
0502.GB
4.2 Driving, steering, braking
f
It is not admissible to stay on the vehicle during driving.
Driving
m
Only drive with the hoods closed and properly locked.
– Start up the truck (see section 3).
– Tilt the control shaft (6) downwards and move it in the desired direction by either
pulling the vehicle forwards (V) or pushing it backwards (R).
Steering
– Swivel the control shaft (6) to the left or the right.
m
In narrow bends, the control shaft protrudes beyond the truck contour!
Braking
f
The vehicle’s braking distance depends to a great extent upon the nature of the floor
surface. The operator is to take this into account when moving the vehicle.
The truck can be braked in two ways:
– By hand (by pushing or pulling against the direction of motion).
– Brake pedal (parking brake only).
E 5
0502.GB
4.2 Driving, steering, braking
f
It is not admissible to stay on the vehicle during driving.
Driving
m
Only drive with the hoods closed and properly locked.
– Start up the truck (see section 3).
– Tilt the control shaft (6) downwards and move it in the desired direction by either
pulling the vehicle forwards (V) or pushing it backwards (R).
Steering
– Swivel the control shaft (6) to the left or the right.
m
In narrow bends, the control shaft protrudes beyond the truck contour!
Braking
f
The vehicle’s braking distance depends to a great extent upon the nature of the floor
surface. The operator is to take this into account when moving the vehicle.
The truck can be braked in two ways:
– By hand (by pushing or pulling against the direction of motion).
– Brake pedal (parking brake only).