XI
Figure 11: E1 Frame Relay Tab Window
Table 9: Field Descriptions for the Frame Relay Tab
To configure the E1 interface with PPP options, see “PPP Option with PPP Tab
Window” on page VIII.
To configure the E1 interface with the Cisco HDLC, see “Cisco HDLC Option with
Cisco HDLC Tab Window” on page IX.
Field Description
No-Keepalives checkbox Enables no-keepalives
Type Sets the frame relay LMI type
ANSI: American National Standards Institute supports data rates
up to 8 Mbps downstream and 1 Mbps upstream.
ITU: International Telecommunications Union supports data
rates of 6.144 Mbps downstream and 640 kbps upstream.
Interface Name Sets the subinterface name
Inverse ARP checkbox Enables inverse Address Resolution Protocol (ARP) for the
subinterface
Frame Relay DLCI Assigns a DLCI to the subinterface
Interface IP Sets the IP address for the subinterface
Netmask Sets the netmask for the subinterface
Gateway Sets the gateway for the subinterface
To Next Page
Loading...
