EasyManua.ls Logo

JVA Z13 - Agricultural Mode; Group Simultaneous Pulse Feature; Remote Control Unit (Optional); Cabling

JVA Z13
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 24
Description
© JVA Technologies www.jva-fence.com JVA Z13 Manual
5.10 AGRICULTURAL MODE

way test the fence without triggering any of the alarms. This mode should



threshold, however it will not trigger the alarm.
5.11 GROUP SIMULTANEOUS PULSE FEATURE
-
-
  
units in a group have simultaneous high voltage output pulses and act as

         
   
page 71
5.12 
-
arm the energizer via a compact key chain fob remote control. If using the
remote control the siren can be used to acknowledge arming with 1 beep
   “9.5.11 Chime Mode
.


5.13 CABLING
High voltage cabling (fence feed and returns) should be run using suitably
-
able. High voltage cables must never be run within the same conduit as low
voltage cables. A minimum distance of 30mm should be kept between high
voltage and low voltages cables.

not enter the enclosure via the cable entry area a silicon sealant (neutral
cure) must be used to seal all the cable passages.

Table of Contents

Related product manuals