JVA Z13 - Installation Programming Options; Programming Mode Access

Installation Programming Options
Page 37 © JVA Technologies www.jva-fence.com
9 INSTALLATION PROGRAMMING
OPTIONS
  

“2.1 Changing

9.1 PROGRAMMING MODE
To enter Programming mode, enter the 6-digit Installer PIN (default is
012345) followed by *, 0, # keys. The keypad will beep twice to indicate
that the command was accepted. If the Installer PIN was incorrect, the key-


9.2 
*, #

9.3 CHANGING THE INSTALLER PIN
The installer PIN may only be changed while in Programming mode.
To enter a new installer pin, press 00 followed by the new 6-digit Installer
PIN, then the  key.
If you cannot remember your Installer or User PIN, return the unit’s memo-




9.4 CHANGING AN OPTION


-

the programming is completed, exit from Programming mode. (See above)
For example, to change the power level to maximum, enter programming
mode and press 0199#, and the keypad will beep twice to indicate that the