Control
Page 31 © JVA Technologies www.jva-fence.com
7 CONTROL
may be armed and disarmed using any of the following:
• Key switch or remote switch connected to the control input (IN1)
• Remote control radio receiver connected to IN1
•
• JVA GSM module
• Windows PC running JVA Perimeter Patrol
• Low level interface (wired to control inputs and relay outputs) from a
-
tem (PSIM)
7.1 ARMING THE FENCE USING THE KEYPAD.
Enter your (Default User PIN is 1234).
Make sure the red ARM light comes on.
•
• The fence will power up and if all is well (no faults) the system will be
ready to deter and detect.
• If there is a fault on the fence and it cannot achieve full voltage, the
keypad will indicate that there is a fault.
• To disarm the system, enter your User PIN and press #.
7.2 ACTIVATING LOW POWER MODE
To switch to Low Power mode, enter your . In Low Power
Enter your User PIN and press *42# to switch back to Full Power mode.
connected to a control input, if it has been programmed accordingly. See
To Next Page
Loading...
