JVA Z13 - Status Codes Interpretation

Technical Information
Page 35 © JVA Technologies www.jva-fence.com
8.4 STATUS CODES
Status LED
Number of Flashes
 
1 Tamper detected Fix tamper input
2 Mains supply fail Restore mains power
3 


4 PCB service fault Seek advice from your in-
staller or distributor





the energizer will eventually stop. Once mains power has been restored
-


If an error has momentarily caused the energizer to stop pulsing, this can
be corrected by disarming and rearming the unit. Should the error recur
return the unit for service.