Installation Programming Options
Page 45 © JVA Technologies www.jva-fence.com
bridging Threshold. At this level a fence (return) voltage normally reading
falls to less than 6.7kV.
running voltage, otherwise if the load is released (fence bridged) voltage
-
the un-loaded fence to rise to 8.3kV or higher, thus triggering the Alarm.
9.5.15
value.
+1: Enables Siren Acknowledge. The siren will chirp once for armed and
twice for disarmed.
+2: Enables a home alarm style entry/exit delay for the gate input.
+4: Sets the keypad bus baud rate to 4800 (default is 2400), all units in a
group, PC and keypad must be set to the same baud rate. The change will
+8: Sets the keypad bus baud rate to 9600 (default is 2400)
+16: Enable Low Power Bite mode. If the Energizer (running in Low Power
+32: Enables Bite to Low Power mode. If the Energizer (running in High
A “Fence Touch“ is detected when the fence voltage drops below the
threshold for one pulse
To Next Page
Loading...
