JVA Z13 - Changing the User PIN

Page 32
Control
© JVA Technologies www.jva-fence.com JVA Z13 Manual

7.3 WHEN AN ALARM OCCURS
If the system is armed and the fence is tampered with, the fence light will

on. If the energizer is connected to an alarm system for monitoring, an
alarm signal will be sent to the alarm company monitoring the alarm sys-
tem.
An alarm will also sound if the gate input is opened and the entry/exit delay

7.4 TO SILENCE THE ALARM
Enter 1470on the Keypad. This will silence the Siren but not disarm the





be ready to sound again for the next Alarm.

7.5 CHANGING THE USER PIN
• Enter the current  (default is 1234) and press . This enters
User Programming mode.
• Enter your new  (must be 4 digits) and then .
• Press  to exit User Programming mode.
• Make sure your new User PIN works by using it to arm the energizer.