JVC MX-GA77

1-11
MX-GA77
Prior to performing the following procedure, remove
the CD tray.
Remove the screw A attaching the sensor board on
the CD tray.
Remove the sensor board releasing the two tabs a.
Disconnect the harness from the connector CW1 on
the sensor board.
1.
2.
3.
Removing the sensor board (See Fig.5)
Prior to performing the following procedure, remove
the CD tray and sensor board.
Remove the screw B attaching the turn tray. Detach
the turn tray from the base tray.
Pull outward the tab b attaching the turn tray motor
on the base tray and detach the turn tray motor.
1.
2.
Removing the turn tray motor
(See Fig.6 and 7)
Introductory notes:
Base tray + Turn tray = CD tray
Fig.7
Fig.6
Tab a
Tab b
Sensor board
CW1
Turn tray
Base tray
CD tray (reverse side)
Base tray (upper side)
B
Turn tray motor
A
Fig.5