4 If equipped, at the rear of the rocker lever cover install the
banjo bolt and sealing washers connecting the breather oil
drain line to the rocker lever cover. Tightening torque 12 Nm
(106 in-lb).
NOTE
Not all engines with an internal mounted crankcase breather are
equipped with an external breather oil drain line. On some engines
the breather oil drain line is internal to the breather connection tube
(
C)
.
5 Prior to connecting the breather connection tube to the rocker
lever cover, apply clean engine oil to the o-ring located on the
breather tube connection.
6 Connect the breather tube connection to the rocker lever
cover.
7 Tighten the capscrews. Tightening torque 10 Nm (89 in-lb).
8 Connect the batteries. See equipment manufacturer service
information.
9 Operate the engine and check for leaks.
Engine steam cleaning
WARNING
BURN HAZARD!
Hot steam can cause serious personal injury.
When using a steam cleaner, wear safety glasses or a face shield,
as well as protective clothing.
Steam is the best method of cleaning a dirty engine or a piece of
equipment. If steam is not available, use a solvent to wash the
engine.
Protect all electrical components, openings, and wiring from the full
force of the cleaner spray nozzle.
1 Engine – 1.5 Mechanical components of the engine 17
TL2 Maintenance Manual
591 003 Default
To Next Page
Loading...
