2 Transmission
2.3 Mechanical transmission
Clean and examine the transmission exterior
CAUTION
Avoid skin contact with transmission oil. Use protective gloves.
NOTE
Ensure that the used cleaning equipment, drained transmission oil,
and filters are delivered to a hazardous waste collection point in
accordance with the applicable instructions.
CAUTION
DO NOT pressure wash the transmission electrical connectors.
Water and detergent cause the electrical contacts to corrode and
become faulty.
1 Clean and examine the exterior of the transmission at regular
intervals. Intervals must be specified according to severity of
service and operating conditions.
2 Examine the transmission for:
•
Loose bolts: transmission and mounting components
•
Fluid leaks (refer to SIL 12-WT-02) repair immediately
•
Loose, dirty, or improperly adjusted throttle sensor
•
Damaged or loose hoses
•
Worn, frayed, or improperly routed electrical harnesses
•
Dented, worn, or out-of-phase driveline U-joints and slip
fittings
•
Clogged or dirty breather
•
Transmission fluid for evidence of engine coolant
Tighten the transmission mounting screws
The transmission bracket is mounted on the tractor frame with four
mounting screws.
2 Transmission – 2.3 Mechanical transmission 3
TL2 Maintenance Manual
591 003 Default
To Next Page
Loading...
