Kane 358 - BATTERIES; REPLACING BATTERIES; CHARGING NIMH BATTERIES

9KANE 358 MANUAL
BATTERIES
BATTERY TYPE
This analyser uses rechargeable Nickel Metal Hydride (NiMH) batteries
- Using other battery types may void your analyser’s warranty.
WARNING
Although you can use Alkaline batteries you must not charge your
analyser with Alkaline batteries tted.
Do not mix NiMH cells of dierent capacities or from dierent
manufacturers - All batteries must be identical.
REPLACING BATTERIES
Turn over your analyser & remove its protective rubber cover to nd trhe
battery compartment & t 3 NiMH “AA” rechargeable batteries ensuring
they are tted with correct battery polarity. Replace battery cover &
protective rubber cover.
TIME AND DATE
After changing batteries reset your analyser’s time & date.
CHARGING NIMH BATTERIES
Your KANE358 uses a standard Micro USB connector - For best
results turn it o then connect your charger. The charging indicator will
illuminate and turn o when the need for charge is over.
Your rst charge should be for 8 hours - Thereafter NiMH batteries can
be “topped up” at any time, even for short periods.
If your batteries discharge so that the analyser enters a low power
shutdown, 1 hour’s charge provides approx 2 hours continuous use.
BATTERY DISPOSAL
Always dispose of depleted batteries using approved disposal methods
that protect the environment.