MiniVision2 – User Manual
Page 10 / 71
Activation
Insert SIM card
MiniVision2 is only compatible with Nano-SIM cards (4FF format).
To insert the SIM card, turn the phone over, locate the notch on the bottom left of the phone and
lift the back cover. The SIM connector is located under the battery on the top left side.
Put the SIM card into the compartment located on the right of the SIM connector, the chip should
be pointing down and the beveled corner at the bottom left. Push on the SIM card lightly with a tip
of your finger and carefully slide it all the way to the left.
Good to know: you can add a memory card into the SD connector located on the bottom right
under the battery if you want to expand the internal memory of the MiniVision2.
Insert the battery
Insert the battery by placing the bottom edge first in its slot. The lower edge is identifiable thanks
to the load contacts. Then clip the top of the battery. The battery will fit easily in its slot only if
inserted the proper way. Do not attempt to force the battery into the slot. Finally, replace the back
cover of the phone and press firmly.
Charge the battery
If you use the battery for the first time, we recommend you charge the battery for at least four
hours. After that, the battery can be recharged according to your usage.
The autonomy of MiniVision2 depends on the use you make of it. The more you use the device
and the faster the battery will discharge. You can optimize battery usage by adjusting certain
settings such as screen brightness, sleep mode delay, or turning off Bluetooth and Wi-Fi. For more
information, please refer to the « Settings » section.
To charge the battery, connect the USB cable between the MiniVision2 and the wall charger
supplied with the product. Then connect wall AC charger to a wall outlet.
Good to know: You can also use the charging cradle to charge the battery. Connect the USB cable
to the charging cradle. Then simply stands the MiniVision2 into the cradle to start the charge.
Please note that the protection case is not compatible with the charging cradle, remove it when
using cradle.
Turn the MiniVision2 on and off
To turn your MiniVision2 on, press and hold the End call button located at the bottom right of the
navigation panel. When the device vibrates, release the button. If the phone does not start, check
if the battery has been correctly installed, if necessary, restart the battery installation procedure.
To turn the device off, press and hold the End call button. Then press the OK button to confirm
that the device has been switched off. A light vibration is felt before the device is totally turned off.
Sleep mode
When the home screen is active, a short press on the End call button will enter the product into
sleep mode.
In sleep mode, the display is off, and the keypad is disabled, however the functions remain active.
You can always receive your calls and messages.
To exit from sleep mode, press the End call button again to enter operational mode and return to
the Home Screen. MiniVision2 will then announce, "Home Screen".
To Next Page
Loading...
