Kärcher MC 130 - EU Declaration of Conformity

112 English
Adjusting protective covers to different tyres
The protective covers can be adjusted to suit different tyre widths.
1 Tyres, narrow
2 Protective cover pushed in
3 Tyres, wide
4 Protective cover pulled out
1. Release the screws, three each at the front.
2. Adjust the protective cover to suit the width of the tyres.
3. Unscrew the screws, three each at the rear.
4. Offset the protective cover.
5. Re-tighten all screws.
EU Declaration of Conformity
We hereby declare that the machine described below complies
with the relevant basic safety and health requirements in the EU
Directives, both in its basic design and construction as well as in
the version placed in circulation by us. This declaration is invali-
dated by any changes made to the machine that are not ap-
proved by us.
Product: Sweeper
Type: PF-D
Currently applicable EU Directives
2006/42/EC (+2009/127/EC)
2014/30/EU
2000/14/EC
Harmonised standards used
EN 13019
EN ISO 14982:2009
Conformity evaluation procedure used
2000/14/EC: Appendix V
Sound power level dB(A)
PF-D (MC130)
Measured: 101
Guaranteed: 104
The signatories act on behalf of and with the authority of the com-
pany management.
Documentation supervisor: S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Ph.: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2018/07/18
Tyre pressure (bar)
at 40 km/h
1.0 1.1 1.5 1.8 2.2 2.6
BKT LG306 26x12-12 8 PLY
Grass tyres
Deestone D408 26x12-12.00 - 12 10 PLY
Traction tyres
Axle load (kg) 1000 1200 1400 1600 1800 2000
Tyre pressure (bar)
at 30 km/h
1.3 1.5 1.8 2.0 2.5 2.9
Tyre pressure (bar)
at 40 km/h
1.3 1.5 1.8 2.0 2.5 2.9
Chairman of the Board of Management
Director Regulatory Affairs & Certification
H. Jenner
S. Reiser