English 87
1 Waste container
2 Retaining pins
3 Locking pin
4 Frame
5 Hydraulic connection
9. Push the retaining pin in and secure with the locking pin.
10.Connect the electrical and hydraulic connections.
1 Spray water hose
2 Recycling water hose (option)
11.Connect the recycling water hose (option).
12.Connect the spray water hose.
1 Suction hose
13.Plug the suction hose tightly onto the waste container.
Removing the waste container
Waste container emptied.
Water reservoir emptied.
1 Suction hose
1. Turn the steering wheel all the way to the right to provide better
access to the articulated joint.
2. Disconnect and remove the suction hose from the waste con-
tainer.
1 Spray water hose
2 Recycling water hose
3. When the suction mouth is installed: Disconnect the hoses for
the recycling water and spray water.
4. Steer the vehicle straight ahead.
1 Waste container
2 Retaining pins
3 Locking pin
4 Frame
5 Hydraulic connection
5. Adjust the rear mounting supports to an appropriate height.
6. Fit the rear mounting supports.
7. Disconnect the electrical and hydraulic connections from the
waste container.
To Next Page
Loading...
