Kawai MP7 - Key Setup

58
EDIT Menu
5 Key Setup
1. Touch Mode
This parameter selects the trigger point for the keyboard.
A fast/higher trigger point may be useful when playing sounds that are
traditionally played on non-weighted keyboards such as organ or synth.
Touch Mode Description
Normal The keyboard trigger point is normal.
O-Fast The keyboard trigger point is earlier than normal.
O-Fast2 The keyboard trigger point is earlier than O-Fast.
* When either fast mode is selected, touch response will be disabled.
* This parameter is common for all four zones.
2. Touch Curve
This parameter selects the touch response curve of the
keyboard for the selected zone.
* For more information about touch curve types, please refer to page 46.
* For information about creating User Touch Curves, please refer to the
User Edit explanation in the SYSTEM menu chapter (page 110).
* This parameter will not be available when tonewheel organ mode is
selected.
3. Octave Shift
This parameter adjusts the amount of octave transposition for
the selected zone.
4. Zone Transpose
This parameter adjusts the amount of transposition for the
selected zone.
5. Key Range Zone Lo
This parameter denes the bottom key of the selected zone.
* For more information about adjusting the zone key range, please refer
to page 24.
6. Key Range Zone Hi
This parameter denes the top key of the selected zone.
* For more information about adjusting the zone key range, please refer
to page 24.
7/8. Velocity Switch
These parameters enable velocity switching, and set the velocity switch type and value.
Velocity Switching is useful when combining multiple zones, allowing dierent sounds to be played depending on the velocity of the key strike.
Switch Mode Description
O The selected sound will play normally (i.e. no velocity switching).
Soft The selected sound will play only when the velocity is lower than the dened velocity switch value.
Loud The selected sound will play only when the velocity is higher than the dened velocity switch value.
* For more information about velocity switching, please refer to page 47.
9. Key Scaling Damping
This parameter determines whether or not damping (velocity
reduction) should be applied to a zone over a specic range.
This parameter may be useful when layering a piano sound with a strings
sound, in order to reduce the level of the strings in the higher key range.
10. Key Scaling Key
This parameter denes the point on the keyboard from which
Key Scaling Damping should be applied, up to the highest key.
EDIT Menu parameters (EXT mode)
normal, off-fast, off-fast2
value: –3 ~ +3 octaves
6 types + 5 user
value: –12 ~ +12
range: a-1 ~ c7 range: a-1 ~ c7
off, soft, loud
on, off range: a-1 ~ c7