Kawai MP8 - Damper Effect (Int Piano Only); String Resonance (Int Piano Only); TX Ch (Ext Only); TX Prg # (Ext Only)

32
the piano response for each player and each sound.
The effect is only available for the internal piano sounds. Other sounds cannot
use this parameter.
Normal: Produces the normal tone of an acoustic piano throughout the entire
dynamic range.
Mellow: Reproduces the effect of a softer hammer surface. It produces a
mellower tone throughout the entire dynamic range.
Dynamic: This setting is not possible with an acoustic piano. Softly played
notes will have the tone of a mellow voicing and notes played harder
will have the tone of a bright voicing. This setting produces a
dramatic change from mellow to bright throughout the entire
dynamic range.
Bright: Produces a brighter tone throughout the entire dynamic range.
6.2.4 Damper Effect (Int Piano only)
When the sustain pedal id depressed, the volume of the whole resonancecan
be changed to the level you prefer. The value change from 0 (off) to 10.
* The display shows this parameter only when Piano sound is selected.
6.2.5 String Resonance (Int Piano only)
The volume of string resonance can be changed to the level you prefer. The
value change from 0 (off) to 10.
<String Resonance>
In acoustic pianos, there are strings corresponding to each key. When a key
is pressed, strings of other keys in the related harmonic series to the note
played resonate. This effect is called "sound resonance", which makes the
sound of acoustic piano full and rich.
* The display shows this parameter only when Piano sound is selected.
6.2.6 TX Ch (Ext only)
This parameter sets the MIDI transmit channel for the selected zone. All
MIDI data for the selected zone will be transmitted on this channel. Make
sure that the receiving channel for any external MIDI devices to be controlled
from this zone is set to the same channel as the zone.
6.2.7 TX Prg # (Ext only)
This parameter determines if a Program Change Number will be transmitted
(On) or not (Off) when a SETUP is recalled. If you want to switch sounds
on external MIDI devices every time you call the Setup turn this parameter
ON.
6.2.8 Prg # (Ext only)
This parameter determines which Program Change Number will be
transmitted when a SETUP is recalled. When the TX Prg # is set to Off, this
page won’t be displayed. Select the desired PRG number for the sound you
want to select on the external MIDI device.
3External
TX Channel = 1
3External
TX Prg # = On
3External
Prg # = 001
1 Concert Grand
DamperEffect= 5
1 Concert Grand
String Reso.= 5