39
6.3.5 FSW Control Change Number
This parameter assigns a Control Change Number to the Footswitch
connected to the FSW jack on the rear panel.
See page 58 for the list of Control Change numbers.
If the SW is selected, the footswitch is used to turn on/off the SW button.
When the System parameter FootSW is “Setup+” this page won’t be
displayed.
6.3.6 EXP Control Change Number
This parameter assigns a Control Change Number to the Expression Pedal
connected to the EXP jack on the rear panel.
See page 58 for the list of Control Change numbers.
If the AFT is selected, the expression pedal is used to send After Touch
information.
If the “Pedal Wah” is selected in EFX, the pedal works as a Wah Pedal
regardless of the setting in this parameter.
Note:
When the following Numbers are selected for the FSW Control Change
Number or the EXP Control Change Number, the functions affect the
internal sounds, too.
1. Modulation Wheel (MOD)
7. Volume (VOL)
10. Pan (PAN)
11. Expression Controller (EXP)
64. Damper Pedal (HLD)
66. Sostenuto (SST)
67. Soft Pedal (SFT)
6.3.7 Master Volume
Adjust the total volume of the SETUP.
The value changes from 0 to 127.
COMMON
FootSW CC# = SST
COMMON
ExpPdl CC# = EXP
COMMON
Master Vol = 127
To Next Page
Loading...
