Kawai MP8 - Foot Switch Mode; System Dump; Dump Current; Dump All

45
8.2.12 Foot Switch Mode
This parameter sets the mode of FootSW's function.
Normal: The type of controller assigned to the footswitch is a common Setup
parameter "FootSW CC#". (See P.39)
Setup+: The footswitch is pushed 1 time, and Setup number will be increased
by 1.
Note:
When the value is "Setup+", FootSW CC# page won't be displayed.
8.3 System Dump
8.3.1 Dump Current
This function transmits the current and active settings of the MP8 as a System
Exclusive Message via the MIDI OUT.
Press the SYSTEM button. Then press the MENU-UP button until “Dump
Current” appears on the display.
Press the VALUE-UP button. The display will ask for confirmation.
To cancel Dump Current at this point, press the VALUE-DOWN button.
Otherwise, press the VALUE-UP button again.
The display will change to read “Completed!!”. Dump Current is complete.
Note:
Loading the data back to the MP8 will change the current settings.
SETUP and SYSTEM data will not change. You can use this function to
temporarily change the setting from your sequencer. If you want to
save the setting, you must use the STORE procedure and save as Setup.
8.3.2 Dump All
This function transmits all the Setups of the MP8 as System Exclusive
Messages via the MIDI OUT. Use this function to backup your Setups on an
external MIDI sequencer.
Press the SYSTEM button. Then press the MENU-UP button until “Dump
All” appears on the display.
Press the VALUE-UP button. The display will ask for confirmation.
To cancel Dump All at this point, press the VALUE-DOWN button.
Otherwise, press the VALUE-UP button again.
When the data is done transmitting, the display will change to read
“Completed!!”. Dump All is complete.
Note:
Dump Current
Press VALUE UP
Dump Current
Sure?
Dump Current
Completed!!
Dump All
Sure?
Dump All
Completed!!
Dump All
Press VALUE UP
SYSTEM
FootSW =Normal