44
8.2.7 Multi-Timbral Mode
Multi-Timbral Mode allows the MP8 to receive data on more than one MIDI
channel simultaneously. In this mode, the MP8 can play different musical
parts with different sounds for each part.
On: This is a flexible 16 part multi-timbral setup. (On 1 and On 2)
MP8’s normal program change numbers are assigned in On 1, and
General MIDI program change numbers are assingned in On 2.
(please see page XX for a list of the program change numbers.)
Off: This turns off the multi-timbral capability. Only the system channel
will be active and only the preset sound currently selected will be
heard when a MIDI signal is received.
8.2.8 Receive Channel
This parameter determines whether or not a particular MIDI channel will
receive incoming MIDI data from an external source. This parameter can be
used to filter out data on specific MIDI channels that are not intended for the
MP8.
On: The MP8 responds to MIDI data received on this channel.
Off: The MP8 ignores MIDI data received on this channel.
When the Multi-Timbral Mode is set to Off, this page won’t be displayed.
8.2.9 LCD Contrast
This parameter adjusts the contrast of the LCD display.
As the value changes higher, the contrast gets sharper. The value changes
from 0 to 10.
8.2.10 LED Brightness
This adjusts the brightness of the LEDs. You can choose from High or Low.
The Low setting is designed for dark stages, while the High setting is good
for bright ambience.
8.2.11 Out Mode
Sometimes it is convenient to have two mono outputs instead of a stereo
output.
In this case one mono output can be used for your own monitor system and
the other goes to the mixing console.
Stereo: The signal on the Line-Outs is normal stereo.
2xMono: The signal on the Line-Outs is mono on both jacks
Note:
To avoid unexpected sounding some stereo effects like AutoPan will be
turned off, when 2xMono is selected.
SYSTEM
RX Ch 1 = On
SYSTEM
Multitimbre= Off
SYSTEM
LCD Cont. = 10
SYSTEM
LED Bright.=High
SYSTEM
Out Mode =Stereo
To Next Page
Loading...
