KBR multicomp F144-MS-1V1C1TI6DO6RO-3 - Page 40

Rev. 1.00
22586_EDEBDA0253-0318-1_EN
40
KBR multicomp F144-3 6DO/6RO Description of the display window
 Sampling rate:
The power frequency tracing settings are displayed in this submenu. If the
setting is "Auto", the sampling rate is tracked automatically in a range from 40
to 70 Hz. Alternatively, a  xed sampling rate of 50 Hz or 60 Hz can be set.
 Reset:
The Reset menu item o ers various methods of resetting the programmed
controller parameters. The programmable parameters are reset to the default
settings.
This has the advantage that all con gured parameters are deleted at the same
time and the controller restarts with the default settings.
 Perform reset:
Extras menu, Reset menu item
Press
U = Reset  ashes
Press
U and V simultaneously = done is displayed
After about 2 seconds, Reset is displayed again
NOTE
The reset process can be interrupted by pressing X.
 Contrast setting:
The contrast settings of the LCD can be changed in this submenu. Setting
range: 0 to 10.
 Brightness setting:
The LCD brightness can be changed in this submenu.
Setting range: 0 to 9.
 Dimmer brightness:
The LCD dimming can be changed in this submenu. Setting range: 0 to 9. The
brightness is reduced after a set time of 15 minutes.
 Light load limit:
In this submenu, the light load detection limit can be changed to either 15
mA or 50 mA.
 Light load delay:
The light load detection delay time can be changed in this submenu. It can be
varied between 1 and 60 minutes.
 Fan relay:
In this submenu, you can set the last stage output (stage 12) as a compensa-
tion stage output or fan output.