EasyManua.ls Logo

KEEWAY K-LIGHT 125 - Engine Break-in and Fuel Efficiency; Parking Procedures

KEEWAY K-LIGHT 125
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-3
EN
5
Operation and important riding points
Running-in the engine
There is never a more important period in
the life of your engine than the period be-
tween 0 and 1000 km (600 mi). For this rea-
son, you should read the following material
carefully.
Since the engine is brand new, do not put
an excessive load on it for the rst 1000
km (600 mi). The various parts in the en-
gine adapt themselves creating the correct
operating clearances. During this period,
prolonged full-throttle operation or any
condition that might result in engine over-
heating must be avoided.
0–1000 km (0–600 mi)
Avoid prolonged operation above 5600 r/
min.
NOTICE
After 1000 km (600 mi) of operation,
the engine oil must be changed and
the oil lter cartridge or element re-
placed.
1000–1600 km (600–1000 mi)
Avoid prolonged operation above 6800 r/
min.
1600 km (1000 mi) and above
The vehicle can now be operated normally.
NOTICE
• Maintain the engine running
speed below 8500 rpm.
• If any engine trouble should occur
during the engine running-in pe-
riod, immediately have a Keeway
dealer check the vehicle.
Parking
When parking, stop the engine, and then
remove the key from the main switch.
WARNING
• Since the engine and exhaust sys-
tem can become very hot, park in
a place where pedestrians or chil-
dren are not likely to touch them
and be burned.
• Do not park on a slope or on soft
ground, otherwise the vehicle
may overturn, increasing the risk
of a fuel leak and re.
• Do not park near grass or other
ammable materials which might
catch re.
COPY - Moto GB - Grant Martland - grantmartland@motogb.co.uk

Table of Contents