To Next Page

To Previous Page

18-104 SCPI Command Reference 2400 Series SourceMeter

User’s Manual

STATus subsystem

The STATus subsystem is used to control the status registers of the SourceMeter. The com-

mands in this subsystem are summarized in Table 18-8.

NOTE These registers and the overall status structure are fully explained in Section 15,

“Status Structure.”

Read event registers

[:EVENt]?

:STATus:MEASurement[:EVENt]? Read Measurement Event Register

:STATus:QUEStionable[:EVENt]? Read Questionable Event Register

:STATus:OPERation[:EVENt]? Read Operation Event Register

Description These query commands are used to read the contents of the status event

registers. After sending one of these commands and addressing the

SourceMeter to talk, a value is sent to the computer. This value indicates

which bits in the appropriate register are set.

Program event enable registers

ENABle <NDN> or <NRf>

:STATus:MEASurement:ENABle <NDN> or <NRf> Program Measurement Event Enable

:STATus:QUEStionable:ENABle <NDN> or <NRf> Program Questionable Event Enable

:STATus:OPERation:ENABle <NDN> or <NRf> Program Operation Event Enable Register

Description These commands are used to set the contents of the event enable

registers.

Read condition registers

CONDition?

:STATus:MEASurement:CONDition? Read Measurement Condition

:STATus:QUEStionable:CONDition? Read Questionable Register

:STATus:OPERation:CONDition? Read Operation Condition

Description These query commands are used to read the contents of the condition

registers.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Keithley SourceMeter 2400 Series User Manual

Other manuals for Keithley SourceMeter 2400 Series