Series 2600 System SourceMeters Reference Manual Getting Started 1-15
Return to Section 1 topics 2600S-901-01 Rev. A / May 2006
Beeper
With the beeper enabled, a beep will be issued to acknowledge the following
actions:
• A short beep, emulating a keyclick, is issued when a front panel key is
pressed.
• A short beep is also issued when the rotary knob is turned or pressed.
• A longer beep is issued when the source output is turned on.
To control the beeper from the front panel, select MENU > GENERAL > BEEPER,
then ENABLE or DISABLE the beeper as desired.
Via remote, use the beeper.enable command to control the beeper. For
example, the following enables the beeper:
beeper.enable = 1
Display modes
Use the DISPLAY key to cycle through the various display modes shown in
Figure 1-3. For the Models 2602 and 2612 only, pressing DISPLAY cycles
between the dual-channel display mode and single-channel modes for CHANNEL
A (SMU A) and CHANNEL B (SMU B). The Models 2601 and 2611 have only one
channel (SMU A). The User State display messages are defined with specific
display commands (refer to
Section 14 for more information on display messag-
ing).
To Next Page
Loading...
Need help?
General
