Series 2600 System SourceMeters Reference Manual Getting Started 1-23
Return to Section 1 topics 2600S-901-01 Rev. A / May 2006
Default settings
The Series 2600 can be restored to one of six setup configurations: five user-
saved setups, and the original factory defaults. As shipped from the factory, the
Series 2600 powers up to original default settings, which are also saved in the five
user setup locations. Original default settings are listed in
Table 1-3. The instru-
ment will power up to whichever default setup was saved as the power-on setup.
Front panel setups
To save a user setup
1. Configure the Series 2600 for the desired operating modes to be saved.
2. Press the MENU key to access the Main menu.
3. Select SAVE-SETUP, then press ENTER.
4. Select the SAVE menu item, then press ENTER.
5. Select the desired user memory location (1 through 5), and press ENTER.
To restore a setup
1. Press the MENU key to access the Main menu.
2. Select SAVE-SETUP, then press ENTER.
3. Select the RECALL menu item, then press ENTER.
4. Select the desired user memory location (1 through 5), or select FACTORY
to restore factory defaults, and press ENTER.
To select power-on setup
1. Press the MENU key to access the Main menu.
2. Select SAVE-SETUP, then press ENTER.
3. Select the POWERON menu item, then press ENTER.
4. Choose FACTORY to power-on to original defaults, or choose
USER-SETUP-NUMBER to power-on to one of the five user setups (1-5).
Press ENTER.
To Next Page
Loading...
Need help?
General
