Series 2600 System SourceMeters Reference Manual Getting Started 1-19
Return to Section 1 topics 2600S-901-01 Rev. A / May 2006
Numeric entry method
1. Use the CURSOR keys or rotate the Rotary Knob to place the blinking
cursor on the most significant digit to be edited.
2. Key in a digit by pressing a number entry key (0 to 9). The cursor will move
to the next digit on the right.
3. Repeat step 2 as needed to set the desired value.
4. Press ENTER to select the value. Pressing EXIT will cancel the change.
Menus
Many aspects of operation are configured through menus. There are two types of
menus: the Main menu (accessed with the MENU key), and Configuration menu
(accessed with the CONFIG key). Each of these is covered below. Refer to the
“
Menu navigation” topic in Section 1 for details on using menus.
Main menu
The Main menu is summarized in Table 1-1 along with the reference for each
main selection. To access menu items, press the MENU key, then make your
selection.
Configuration menus
The configuration menus are summarized in Table 1-2 along with the reference
for each main selection. There are two ways to make selections:
• Press CONFIG, then navigate to the desired submenu.
• Press CONFIG, then press the associated key. For example, pressing
CONFIG followed by REL takes you directly to the Relative menu.
To Next Page
Loading...
Need help?
General
