13-2 Factory Scripts Series 2600 System SourceMeters Reference Manual
2600S-901-01 Rev. A / May 2006 Return to Section 13 topics
Introduction
The Series 2600 is shipped with one or more Factory Scripts saved in its flash
firmware memory. A factory script is made up of a number of functions. Some of
them can be called from the front panel LOAD TEST menu. All of them can be
called using remote programming.
As Keithley Instruments develops additional factory scripts, they will be made
available on the Keithley Instruments web site (www.keithley.com) as a flash
firmware upgrade for the Series 2600. See “
Flash firmware upgrade” for
instructions on upgrading the flash firmware of your Series 2600.
Factory script
KIGeneral
The KIGeneral factory script is made up of the following functions. All of these
functions can be accessed from both the front panel and the remote interfaces.
PulseIMeasureV(smu, bias, level, ton, toff, points)
PulseVMeasureI(smu, bias, level, ton, toff, points)
SweepILinMeasureV(smu, starti, stopi, stime, points)
SweepVLinMeasureI(smu, startv, stopv, stime, points)
SweepILogMeasureV(smu, starti, stopi, stime, points)
SweepVLogMeasureI(smu, startv, stopv, stime, points)
SweepIListMeasureV(smu, ilist, stime, points)
SweepVListMeasureI(smu, vlist, stime, points)
Details on the above functions are provided in the following tables.
To Next Page
Loading...
Need help?
General
