Series 2600 System SourceMeters Reference Manual Status Model D-27
Return to Appendix D topics 2600S-901-01 Rev. A / May 2006
To set register bits:
status.questionable.instrument.* = status.questionable.instrument.SMUA
status.questionable.instrument.* = status.questionable.instrument.SMUB
To read registers:
print(status.questionable.instrument.*)
print(status.questionable.instrument.condition)
print(status.questionable.instrument.event)
B1
B2
To set register bits:
status.questionable.calibration.* = status.questionable.calibration.SMUA
status.questionable.calibration.* = status.questionable.calibration.SMUB
To read registers:
print(status.questionable.calibration.*)
print(status.questionable.calibration.condition)
print(status.questionable.calibration.event)
B1
B2
To set register bits:
status.questionable.over_temperature.* = status.questionable.over_temperature.SMUA
status.questionable.over_temperature.* = status.questionable.over_temperature.SMUB
To read registers:
print(status.questionable.over_temperature.*)
print(status.questionable.over_temperature.condition)
print(status.questionable.over_temperature.event)
B1
B2
Table D-8 (cont.)
Questionable event commands
Command
1
Bit
1. * = '.ntr', '.ptr' and '.enable'; smuX = smua or smub.
To Next Page
Loading...
Need help?
General
