MasterTig 235ACDC, 325DC, 335ACDC, 425DC
Operating manual - EN
2.12 Moving equipment by lifting
If you need to lift MasterTig welding equipment, pay special attention to the safety measures. Also follow the local reg-
ulations. MasterTig welding equipment can be lifted with a mechanical hoist when the equipment is installed securely
on the cart.
If a gas bottle is installed on cart, DO NOT attempt to lift the cart with the gas bottle in place.
DO NOT attempt to lift the equipment with a hoist from the handle.
4 wheel cart (P45MT):
1. Ensure that the welding equipment is properly secured to the cart.
2. Connect the 4-legged chain or straps from the hoist hook to the four lifting points on the cart on both sides of the
welding equipment.
© Kemppi
23
1920900 / 2052
To Next Page
Loading...
