Kemppi MasterTig 235ACDC - 3.5 Remote control

MasterTig 235ACDC, 325DC, 335ACDC, 425DC
Operating manual - EN
3.5 Remote control
For installing remote control, refer to "Installing remote control" on page18.
Hand remote control:
To adjust the welding current, turn the knob on the remote control.
Tip: The remote control comes equipped with a handy clip for hanging the remote onto your belt.
Foot pedal remote control:
To adjust the welding current, press the pedal.
Tip: To shift the foot pedal position on the floor, use the foot pedal handle.
© Kemppi
53
1920900 / 2052