MasterTig 235ACDC, 325DC, 335ACDC, 425DC
Operating manual - EN
Weld Assist automatically sets the following parameters for you:
• Current mode: AC / DC-
• Current: Depends on the machine used
• Pulse (if used): Frequency
• AC and Start & stop parameters: Set to default.
All these parameters can still be modified as per normal for the actual welding.
Weld Assist gives you a recommendation for these:
• Shielding gas flow: "Argon" + l/min and "Helium" + l/min
• Electrode: Diameter
• Filler (if used): Material and diameter
• Number of passes: Number and/or visualization
• Travel speed: mm/min.
Using Weld Assist with MMA welding
1. Go to the Weld Assist view and select 'Start' with the control knob button.
2. Select:
>> The electrode type: Fe-Basic / Fe-Rutile / High Eff. / Ss (stainless steel)/Inox.
© Kemppi
39
1920900 / 2052
To Next Page
Loading...
