Need help?Do you have a question about the Kemppi X3 and is the answer not in the manual?
General| Brand | Kemppi |
|---|---|
| Model | X3 |
| Category | Welding System |
| Language | English |
Provides introductory information and safety notes for the X3 MIG Welder operating manual.
Overview of the X3 MIG Welder system, its components, and intended applications.
Overview of the X3 MIG Welder system components, including power source and wire feeder.
Identification and description of front and back panel components of the X3 Power Source.
Instructions for checking the machine before use and guidelines for proper positioning.
Details on surface inclination, clearance for cooling air, and protection against elements.
Information on harmonic currents and requirements for the power supply network (Ssc).
Guidance on connecting the mains cable, including safety precautions and replacement steps.
Step-by-step instructions for connecting the wire feeder to the power source.
Procedure for correctly attaching the earth return cable to the workpiece.
Details on wheel sets, undercarriage, wire feeder mounting plate, and gas heater.
Steps for loading filler wire, including spool mounting, brake adjustment, and pressure arms.
Guide on how to mount and securely lock the wire spool onto the hub.
Instructions for adjusting the spool brake force to prevent wire spill during operation.
Guidance on setting the correct drive pressure for the filler wire to ensure proper feeding.
Steps for feeding the filler wire through the gun cable to the contact tip.
Information on wire feed rolls and guide tubes for the DuraTorque 400 mechanism.
Explanation of buttons and knobs on the setup panel for welding system control.
Steps to turn on the power source and its initial display sequence.
Details on the LCD display, including parameter settings and welding values.
Description of the ON and overheat indicator LED lights on the control panel.
How to enable/disable parameters and set values for Burn back time and Panel lock code.
Overview of the wire feeder control panel for adjusting wire feed speed and voltage.
Procedure for selecting the correct shielding gas type (CO2 or mixed gas).
Instructions for performing a shielding gas flow test.
Explanation of trigger modes (2T/4T) and the Crater fill function for controlled weld finishing.
Steps for calibrating the wire feed speed to ensure accurate pre-sets and meter readings.
Addresses machine stops, overheating, voltage errors (Err 2, 3, 43), poor welding, and no mains voltage.
Guidelines for checking electrical connections and periodic servicing of the machine.
Information on environmentally responsible disposal of electrical equipment.
To Next Page