Kenwood Excelon KVT-911DVD User Manual

A
16
DVD,VCD Setup Function
B
Setting the Priority Language for Voice
Set the audio language produced from the
speakers.
Touch [ Audio ] to switch the language select
screen. <see p.18>
The language selected in the initial setup is used
immediately after turning power on or replacing
disc. If the initially set language does not exist in
the disc, the priority language defined for each
disc is used.
Setting the Angle Mark Display
With DVDs on which images photographed
from multiple angles are recorded, the angle
can be switched during playback.
Each time you touch [ Angle Mark ], the mode
switches as follows:
" ON "
Angle mark is displayed.
" OFF "
Angle mark is not displayed.
Selecting the Dynamic Range
Each time you touch [ DRC ], the mode switches
as follows:
" Standard "
For more powerful sound at regular volumes
" Midnight"
For powerful sound at low volumes
Doing this operation may raise the sound level.
" OFF "
For the regular sound
This select can be made when the Dolby Digital
signal is inputed.
NOTE
NOTE
NOTE
Setting the Screen Mode
Use the procedure described below to set the
output screen.
Each time you touch [ Screen ], the mode
switches as follows:
" 4:3 LB "
Wide-screen software with pan & scan
specification is played in a letter box screen (with
black stripes on the top and bottom).
" 4:3 PS "
Wide-screen software with pan & scan
specification is played in a panned & scanned
screen (with the left and right sides cut off).
" 16:9 "
Set the picture mode of the wide-screen monitor
to “FULL”
Setting the Priority Language for Menu
Set the language used for the menus (title
menu, etc.).
Touch [ Menu Lang ] to switch the language select
screen. <see p.18>
Setting the Priority Language for
Subtitle
Set the language of the subtitles displayed on
the screen.
Touch [ Subtitle ] to switch the language select
screen. <see p.18>
The language selected in the initial setup is used
immediately after turning power on or replacing
disc. If the initially set language does not exist in
the disc, the priority language defined for each
disc is used.
NOTE
A
B
C
D
E
F
G
H
I
E
F
C
DVD Setup Screen-1
DVD Setup
Screen-2
D

Kenwood Excelon KVT-911DVD Specifications

Power

operating voltage	14.4 V DC
consumed current	10 A
tv antenna unit operating voltage	12 V
tv antenna unit consumed current	1.0 A

Operating Environment

operational temperature range	–10°C to +60°C
storage temperature range	–20°C to +85°C

Monitor Specifications

picture size	6.5 inches wide
display size	142.6(W) × 80.7(H) mm
number of pixels	336.960 pixels
effective pixels	99.99%

Audio Specifications

maximum output power	45 W x 4
full bandwidth power	22 W x 4
preout level	4500mV/10kΩ
preout impedance	≤ 600 Ω

Weight and Dimensions

monitor unit size	180(W) × 50(H) × 185(D) mm
monitor unit installation size	178(W) × 50(H) × 165(D) mm
receiver unit size	225(W) × 40(H) × 168(D) mm
monitor unit weight	2.0 kg
receiver unit weight	1.4 kg
tv antenna unit size	50(W) × 14.5(H) × 500(D) mm
tv antenna unit mass	300 g