Kenwood MDX-F1 User Manual

MDX-F1 (EN)
24
Operation
Contents
If you load a tape in the cassette deck in advance while
the power is off. pressing the TAPE key (2, 3) turns
power on automatically and starts the tape playback.
1 Open the door.
Push the area marked 0 PUSH
OPEN.
2 Insert a tape and close the door.
During playback, the tape
running direction changes
each time the key is pressed.
When playback or recording is started automatically by the
one-touch operation function, etc., the tape is transported
in the direction used the last time the tape was stopped.
(To change the tape transport direction, press the TAPE key
(2, 3) during playback then press the stop key (7).)
Transport direction indicators
Playback of tape
÷ Normal (TYPE ), high (TYPE ), or metal (TYPE ) tape
selection is set automatically.
÷ Remove tape slack before loading.
÷ Close the door securely.
÷ Do not use a tape which is longer than 100 minutes, for
it easily causes troubles such as tape entanglement or
cutting.
Lights
Load a cassette tape.
1
Start playback.
2
TAPE PLAY
0123
2 3
TAPE
TAPE STOP
0000
A
Reverse mode indication
Displayed when the deck is loaded with a tape.
0
2
1
2
0
P
U
S
H
O
P
E
N

Kenwood MDX-F1 Specifications

Amplifier Section

rated output power during STEREO operation	4 W + 4 W
speaker unit	80 mm, cone type

Tuner Section

FM tuning frequency range	87.5 MHz ~ 108 MHz
MW (AM) tuning frequency range	531 kHz ~ 1, 602 kHz

General Specifications

power consumption	38 W
standby power consumption	0.3 W
dimensions (W x H x D)	464 mm x 182 mm x 243 mm
weight (net)	5.4 kg