Operation
44
MDX-F1 (EN)
Timer operation
Contents
Timer operation
Adjust the clock before setting the timer.
Wake-up timer(O.T.T.)
Playback of the selected input source starts at the specified time, and the unit is switched off after one hour. This
timer operates only once directly after setting.
Timer playback, timer recording (PROG.1, PROG.2)
With each of the two timer programs, a selected source can be played (or radio broadcast can be recorded) in the
previously set time period.
AI timer playback (PROG.1, PROG.2)
The volume increases gradually after start of timer playback.
Sleep timer (SLEEP)
The unit is turned OFF automatically after the specified period has elapsed.
Timer playback is possible simply by setting the time.
The source selected last before the unit was switched off will be played. One hour after start of timer
playback, the unit will be switched off automatically.
Setting the O.T.T. timer
Turning the knob switches the function as shown
in the display.
1 O.T.T. SET ?
2 PROG. 1 SET ?
3 PROG. 2 SET ?
1 Select the source to be played.
÷ When the O.T.T. has been set by pressing the
“SET/Demo” key, the display shows “COMPLETE !”.
The time is
advanced.
The time is
returned.
ON time display
(Press the “SET/Demo” key
while the “?” mark is blinking.)
Blinks
2 Select “TIMER SET ?” .
3 Select “O.T.T. SET ?” .
4 Set the ON time.
5 Press the SET/Demo key.
Turning the knob switches the function as shown
in the display.
TAPE RVS. ?
REC MODE ?
AUTO PRESET (TUNER only)
TIMER SET ?
A.P.S. SET ?
÷ The ON time can be set in steps of 5 minutes.
D
e
m
o
MENU
SET
V
O
L
U
M
E
/
M
U
L
T
I
C
O
N
T
R
O
L
D
e
m
o
SET
V
O
L
U
M
E
/
M
U
L
T
I
C
O
N
T
R
O
L
D
e
m
o
SET
0
TUNER
A
M
705
¶
O.T.T. PROG.
6 Execute the O.T.T. operation.
Perform steps 1 and 3 in the
procedure in “Execution and can-
cellation of timer”. u
To Next Page
Loading...
Need help?
Amplifier Section
