Kenwood MDX-F1 User Manual

MDX-F1 (EN)
30
Operation
Let's recording
Contents
Recording on TAPE
CD
0
P
U
S
H
O
P
E
N
2 3
TAPE
D
e
m
o
MENU
SET
V
O
L
U
M
E
/
M
U
L
T
I
C
O
N
T
R
O
L
V
O
L
U
M
E
/
M
U
L
T
I
C
O
N
T
R
O
L
23
D
e
m
o
SET
CD
6
•
TAPE REC
0
1
2
5
4
3
1 Select “TAPE RVS.”.
1 Open the door of deck.
2 Insert a tape.
3 Close the door.
÷ Remove tape slack before loading.
÷ When recording is started, the tape is
transported in the direction selected in
this step.
÷ Wind the tape to the position where
recording is to be started.
1 Press the play key.
2 Press the play key again.
3 Stop key (7) playback.
(2 or 3 lights.)
To reverse the transport direction
Select the reverse mode.
∞
Load a tape in deck.
1
Select the tape transport direction.
2
Set the recording condition.
3
This unit cannot record audio on High (Type ) and
Metal (Type
) cassette tapes.
Select an input source
other than “TAPE”
TUNER (Broadcasts)
CD
MD
The character information display shows
the recording input source.
÷ If a CD or MD has already been loaded, it starts to play now.
Press the 7 key to stop it.
1 Press the TAPE REC key to start recording.
2 Play (or tune) the input source to be recorded.
÷ The recording level is adjusted automatically.
÷ Recording stops automatically when the tape side (s) to be recorded have
been fully recorded.
÷ The recording onto MD is not available during recording onto TAPE.
Example:
To select the CD input
Select the source to be recorded.
4
Start recording.
5

Kenwood MDX-F1 Specifications

Amplifier Section

rated output power during STEREO operation	4 W + 4 W
speaker unit	80 mm, cone type

Tuner Section

FM tuning frequency range	87.5 MHz ~ 108 MHz
MW (AM) tuning frequency range	531 kHz ~ 1, 602 kHz

General Specifications

power consumption	38 W
standby power consumption	0.3 W
dimensions (W x H x D)	464 mm x 182 mm x 243 mm
weight (net)	5.4 kg