Kenwood MDX-F1 User Manual

41
Operation
MDX-F1 (EN)
MD Edit Functions
Contents
1
2
Combining two tracks
(TRACK COMBINE)
Use the following procedure to combine two
tracks into one by deleting a track number.After
this operation, the track numbers of tracks lo-
cated after the combined tracks are decreased
automatically.
Select “COMBINE ?”.
÷ To combine two tracks during playback, press the TRACK EDIT key while the second track is being played.
“COMBINE ?” cannot be selected if the track being played is the first track of the disc.
1 Press the TRACK EDIT key and
select “COMBINE?”.
1 MOVE ?
2 COMBINE ?
3 ALL ERASE ?
4 (Editing cancelled)
If you combine tracks during playback, go to step 3.
When pressed in stop mode
When pressed in play mode
1 DIVIDE ?
2 COMBINE ?
3 ERASE ?
4 (Editing cancelled)
Select the track to be combined.
Select the “MD” input. (Perform the operations in the following procedure while the display is blinking.) *
Image of track combining
To abort operation, press the TRACK EDIT key again.
2 Press the SET key.
SET
TRACK EDIT
CBA ED F
CBA FE
Each press switches the operation.
To increase
track No.
To decrease
track No.
Select the movement destination track number and
press the SET key.
¢4 P.CALL
SET
12
÷ The track which will be the first half of the track after
combination should be longer than 2 seconds.
÷ The combined track will be given the track number and
title of the track which has become the first half after
combination. The track numbers of subsequent tracks
are corrected automatically.
3
4
Enter the track combination.
After editing, eject and remove the mini disc.
COMPLETE !
ENTER
The “WRITING” display indicates that the recorded and
edited data are written in the MD. Be careful not to apply
impact to the unit during it.
If the power cord is unplugged before completion of
“WRITING”, the recorded and/or edited data may be lost.
With the MD, information is written in the disc when
the ejection operation is performed after editing. Af-
ter title input or editing, be sure to eject the minidisc
so that the data is written in it by “WRITING”.
---+ --- ?
MD EDIT
002+ 003 ?
MD EDIT

Kenwood MDX-F1 Specifications

Amplifier Section

rated output power during STEREO operation	4 W + 4 W
speaker unit	80 mm, cone type

Tuner Section

FM tuning frequency range	87.5 MHz ~ 108 MHz
MW (AM) tuning frequency range	531 kHz ~ 1, 602 kHz

General Specifications

power consumption	38 W
standby power consumption	0.3 W
dimensions (W x H x D)	464 mm x 182 mm x 243 mm
weight (net)	5.4 kg