Kenwood MDX-F1 User Manual

31
Operation
MDX-F1 (EN)
Let's recording
Contents
Pause the recording
÷ Press the “TAPE REC” key during recording. It stops
after leaving a non-recorded blank of 4 seconds.
(Press the key again to resume recording.)
Stop the recording
Blinks
Points in CD recording
When recording CD tracks onto a tape, if you leave the cassette deck in record-pause mode beforehand, the
cassette deck recording can be started at the CD starts to be played. (Synchro recording function)
1 Put the CD player in pause mode.
2 Select the track to be recorded with the skip (w2, 3∑) keys.
(The CD player pauses at the beginning of the selected track.)
3 Put the cassette deck in Record-pause mode.
Press the TAPE REC key successively twice to enter record-pause mode.
4 Start playing the CD.
(Synchro recording starts)
÷ Press the stop (7) key to stop recording.
÷ Synchronized recording from MD also is possible with the same procedure.
•
TAPE REC
0
7
STOP
0
REC
÷ Do not take out the cassette tape until the tape trans-
port has stopped completely.

Kenwood MDX-F1 Specifications

Amplifier Section

rated output power during STEREO operation	4 W + 4 W
speaker unit	80 mm, cone type

Tuner Section

FM tuning frequency range	87.5 MHz ~ 108 MHz
MW (AM) tuning frequency range	531 kHz ~ 1, 602 kHz

General Specifications

power consumption	38 W
standby power consumption	0.3 W
dimensions (W x H x D)	464 mm x 182 mm x 243 mm
weight (net)	5.4 kg