6.2.2 Counting system
KERN CCS
y y
Bulk material balance KERN KFP Reference balance KERN CFS
In factory the counting system KERN CCS is preconfigured in a way that no
more changes will be necessary.
When connecting a weighing bridge (not preconfigured by KERN) the follow-
ing must be observed:
Connect weighing bridge with a suitable cable via the second-balance in-
terface.
Allocation of the interface connection see chapter 14.
Configure weighing bridge, see chapter 13
Adjust balance / weighing bridge, see chapter 7.2
6.2.3 Scope of delivery / serial accessories
KERN CFS KERN CCS
• Balance see chpt. 6.2.1) • Ref. balance KERN CFS, see chap. 6.2.1
• Power cable • Bulk mat. balance KERN CFS, see chap. 6.2.2
• Protective cover • Operating instructions KERN CFS/CCS
• Internal battery • Operating instructions KERN KFP
• Operating Manual
12 CFS/CCS-BA-e-1013