By pressing the display changes from one to the other balance.
In the display appears or .
The appeared [T] displays the current balance.
(1) Reference balance KERN
CFS
(2) Bulk material balance KERN
KFP (counting system
CCS)
8.4 Weighing with tare
A tare value can be entered for the reference as well as for the bulk material bal-
ance. Before setting a tare value select an active balance,
see chpt 8.3
8.4.1 Taring
Deposit weighing vessel. After successful stop check press the TARE button.
The zero display and the [T] symbol over NET will appear.
The weight of the container is now internally saved.
Weigh the material, the net weight will be indicated.
The weight of the weighing container will be displayed as a minus number after
removing the weighing container.
To delete the tare value, remove load from weighing pan and press the TARE-
key.
The tare procedure can be repeated as many times as necessary, for example
with initial weighing of several components for a mix (add-on weighing). The limit
is reached when the total weighing range capacity is full.
CFS/CCS-BA-e-1013 21
To Next Page
Need help?
General
