Press , tolerance control is started. The T symbol over appears.
Determine the average piece weight (see chpt. 10.1 or 10.2), place the weighing
goods and check using the tolerance mark T, if the number of the placed pieces
is under, within or above the specified tolerance.
Display of tolerance mark T, if weighing goods are under the specified tolerance
Display of tolerance mark T, if weighing goods within the specified tolerance
Display of tolerance mark T, if weighing goods above the specified tolerance:
The indetermination if the goods to be weighed are within the tolerance limits, can
additionally be given by an acoustic signal (menu item „ „ see chpt. 12.2)
For tolerance control, also only one limit value can be set.
If both limit values are deleted, the tolerance control is deactivated.
CFS/CCS-BA-e-1013 31
To Next Page
Loading...
