CIB-BA-e-2010 11
3 Basic Information (General)
3.1 Utilisation in accordance with specification
The balance you purchased is intended to determine the weighing value of material to
be weighed. It is intended to be used as a “non-automatic balance”, i.e. the material to
be weighed is manually and carefully placed in the centre of the weighing pan. As soon
as a stable weighing value is reached, the weighing value can be read.
3.2 Improper Use
• Do not use balance for dynamic add-on weighing procedures, if small amounts of
goods to be weighed are removed or added. The “stability compensation“ installed
in the balance may result in displaying an incorrect measuring value! (Example:
Slowly draining fluids from a container on the balance.)
• Do not leave permanent load on the weighing pan. This may damage the measuring
system.
• Impacts and overloading exceeding the stated maximum load (max) of the balance,
minus a possibly existing tare load, must be strictly avoided. Balance may be
damage by this.
• Never operate balance in explosive environment. The serial version is not explosion
protected.
• The structure of the balance may not be modified. This may lead to incorrect
weighing results, safety-related faults and destruction of the balance.
• The balance may only be used according to the described conditions. Other areas
of use must be released by KERN in writing.
3.3 Warranty
Warranty claims shall be voided in case
• Our conditions in the operation manual are ignored
• The appliance is used outside the described applications
• The appliance is modified or opened
• Mechanical damage or damage by media, liquids, natural wear and tear
• Improper setup or incorrect electrical connection
• The measuring system is overloaded
To Next Page
Loading...
Need help?
General
